fmsniper

DPMS lower Aero precision upper JP Match 22 inch barrel .5 MOA at 970 yards

so far .5 moa group with factory 168 grain

complete DPMS Stainless barrel, 21.75 inch Upper 308. barrel was 24 inch bull, cut to 21.75 inch, slightly re contoured, with lightening cuts, 11 degree target crown, midwest industry key mod for-end. barrel and bolt only had 40 rounds fired before cutting it barrel is duracaot FDE steel low pro gas block $750.00 plus shipping or trade for tactical scope only missing the forward assist, never installed never seen a reason for it

SOLD

barrel is from Mcgowen barrels not sure who makes the free float tube I bought it a few years back

Sorry

DPMS LR upper with Stainless 7mm08 barrel, 17 inches long and free float rail 1/10 twist 250-300 rounds fired not included----is the following==bolt/carrier, scope and rings, forgrip Youu can use any 308 DPMS bolt $600 open to offers Paint is krylon, you can remove it I have 2 of these, now moving and need to get rid of a few

made from a commercial Mauser interarms, receiver, with hinged trigger gaurd. trigger is timeny side safety set to 3 pounds, receiver is trued, lugs lapped, extractor is jeweled. barrel is a Shilen, Stock is Devcon steel bed, barrel is free floated, all metal is parkerized, 10 shots fired for break in. scope not included, a great hunting rifle, light wieght for trade, what do you have? your FFL must except from and individual

barreled action and all metal minus stock $650.00 Pac-nor super match 26 inch 7mm Rem Mag barrel, 11 degree crown. Mounted on a Commercial FN Mauser action. Work done Lugs lapped Receiver trued, 10 MOA Scope Base glass bed, P&H Side Safety trigger, I have dope out to 1000 Yards buyer, Rifle shoots Berger 168’s fed from the magazine into .25 groups, very accurate Last 1000 yard group was around 5 inches I am running 70.5 grains of retumbo. this is a hunting rifle, and has been used as such, round count is 275 rounds, barrel was blued and duracoated over (some scratches on the duracoat) scope and rings not included with stock, stock is devcon steel bed = Richards micro fit Tac Driver $800.00 NO Scope or rings ------------------------------------------------------

Thanks its a great shooter

Agree I was there for 2 months at Ft. Lewis, nice pine trees but to many Democrats and Libs for me and that is a disease that cant be cured

looking for Antelope and Elk, my prefered taste :)

any good hunting near there?

the job would be near Clovis, never been to that part of NM