Ozzy bear

Thank u much. The boys at polymer 80 have called me at 8 in the morning wed thrust Friday. I've sent them emails pics,ect. They are working with me... Its Ben frustrating .. But I feel like if it just would have Ben super easy. I wouldn't b learning more about every part and its functions. Thanks again everyone

I sent polymer 80 a butt load of pics this morning. There support. Man mike Dolan called me at 8 o'clock. This morning , and said that. They would address all issues, and if need be replace any and all parts. And if they have to they will machine fit my lower and upper.

Well polymer 80 got ahold of me and they are sorting everything out. Thank all of u for your help.

And on my second 308 bolt carrier I am noticing a mark on the end of the firing pin where its catching. And I don't think the firing pin can even move enough to get the primer to pop I will take more pics of bolt

It is only catching some time and feels like it is binding up the spring the last half and three quarters or half an inch, which is why I think I need the 7 and a half to 8 inch tube. And I think it is. Resting the hammer. But maybe not all the way. And I'm hearing a light click, when I pull trigger.

If in brain farting please let me no. I will take corrective criticism. Loll as long as she starts working. Everyone that is helping me. Thank u greatly for your time. Every inch of this build I am being educated. Didn't think the build was gonna b easy, but didn't think it was gonna b difficult , in patiently, and diligently. Working on it.

And yes it is chambering the second round, but barely dimpling primer

When I put the gas tube on and the gas block I plugged the barrel with my finger. And blew through it to make sure it was correct. In my earlier post I mentioned. That I baleave I have the wrong buffer tube. Am looking to figure that out and where and what I need to fix it.

No. I built the whole thing.

No I did not. Was told that that wasn't needed to do in. This kit. I did stick the barrel in vise. Then put a bullet in it and closed the bolt lugs in the barrel. Did not use a no go though.

I bought the upper in the kit. Yes I built it . I know ithas mil spec parts. A Sodom barrel I will look up what company the bolt carrier is made by. But I trulythink my issue is simple. I also built a second upper and both have same problem. Which leads me tword. Buffertube,buffer spring issue. And when a man from the military says look at this before anything else. I tend to listen