Earl o Sammich

I have to tell you pretty much, fornicate off. If you let ass holes like 98Z5V represent you retards than all I have to say to you is fornicate you. .... and buy the way ban this account.

Are you supposed to be an ambassador for this site?. Your ignorance is the sucks.

My typing skills suck. I will admit that. That's what I said 458 SOCOM!!! How do you spell that. But I've got one for you.... what is internal dynamics? that you refer to in your previous post??? You're not referring to internal static dimensions are you....???? Google Dimensions, Dynamics and Statics.

Ever shot the .450 SOCOM? That is what I was referring to. If not, come on over and I'll let you touch off as many as you can take. I'm not normally recoil sensitive. I can shoot the .458 with out much concern, but only for a couple dozen rounds at a sitting. It was half that before I switched from the flash suppressor to the break.

The YHM is for a 450 SOCOM, AR-15 platform. Ended up going with a break. Shoot one and you will know why. It just happened to have the same thread pattern.

It needs a little fitting. It's made for the AR-15 but just a little shaving around where the gas tube enters the upper and the none standard front site shortens the distance from the back of the front site to the front f the barrel nut I may have to shorten by 1/8th to 3/16s inches. Over all I am intensively pleased...

Here is an Ironwood Designs A1, fancy walnut stock set on my Armalite AR10B. Had to scab some parts from one of my other AR10's but you'll gt the gist. ACOG scope coming. That's not the flash hider that's going on this. Have a BE Meyers 240f coming https://www.larue.com/products/b-e-meyers-240f-m60-flash-hider/

I'll get the mic out and measure internals (to the extent I can) tomorrow. Lug width, inside diameter between lugs, max internal diameter, What else?

Thanks 98. Where is this thread you speak of.

26 inch Lilja three groove on top. 18 inch Ballistics Advantege bottom.

...Here is the extension diameter measurements and the a measurement from the Barrel base inside the extension to the front of the extension bolt lugs. If the measurements in the photographs don't look like they are exact it's because I am somewhat handicapped having only two hands. It's hard for me to hold a ruler, flashlight, camera and barrel all at the same time. I measured using a strong magnifying lupe and they are with in a couple of thousandths, if not exact, I would say. I going to assemble in a few days and test fire. Anyone know of a source for AR10B upper receivers by the way?

I was always under the impression that the barrels were interchangeable. I just ordered a barrel from Ballistic Advantage and didn't even pay any attention to the fact that it said "This .308 chambered (DPMS style) barrel...." I have AR10Bs and this is what the upper will be that the barrel goes o. I see out on the home page it says that the barrel extensions are not dimensionally the same. WEll I was curious and took the barrel off one of my AR10Bs and measured it up against the barrel I jsut received from Ballistic advntage. They look the same to me. Here is the reciever side of the barrel extension flange to the edge of the extension for both barrels as well as from the barrel base inside the extension to the edge of the extension.