aadavis94

First thank you to @Albroswift for fixing my bolt for me. Still having an ejecting issue but not as much. Only about 2/3 of the time. Seems like I will go 1-4 shots with it ejecting fine then I get a FTE that prevents the next round from chambering and it jams up. I've got it lubed up real well. I think my next option is an AGBI saw that aero precision just released theirs and am thinking about ordering one.

@Albroswift that's awesome thank you so much. I don't think it's a high pressure bolt. I can't wait to get to try it and see if my problems are solved. If not I'm gonna be buying an adjustable gas block.

Thank you so much. You are a life saver

Yeah that would be great. Thank you!

Yeah I'm still here. Just been busy with all the chaos going on. Not a whole lot I can do right now until I get a new bolt ordered. I'm going to order the KAK double ejector bolt and throw that it, lube the whole gun up wet and take her out to see what happens

So my current bolt is now unless since the ejector is stuck and I cant get it out. In looking at getting one of the KAK double ejector ones. Anybody have any experience with them?

I put it in a vice and used a small c clamp to compress the ejector and spring

No If you had read the last couple posts you would of seen that when I took my old ejector out it went flying and I couldn't find it. I ordered a new one and now it is stuck in the bolt. Don't troll my posts

Ok. So I went to install my new ejector and proceeded to bend the roll pin upon install 😅😐. Best place to order a new one from? Also now my ejector seems to be stuck and won't move at all.

Ok. So I went to install my new ejector and proceeded to bend the roll pin upon install 😅😐. Best place to order a new one from?

I didn't even notice I put the wrong picture up. Here is the correct one.

Thank you!!

Where is the best place to order an ejector from?

Pulled my bcg apart. Does this look right? I went to pull my ejector out and it shot into deep space orbit so it looks like I'm ordering a new one of those 😅

gas port is reading 0.085

Idk if it locks back or not after the last round. I am going to lube her up real good and go try again next weekend.

Yes it is

I'm shooting factory loads, 155-180 grain. I've probably put about 75-100 rounds through it so far. Next time I go out I will make sure to lube her up even more. I've been using gun grease but will try oil next time.

So I've built an AR .308 and I'm having FTE and FTF issues Aero precision: M5 upper, lower and hand guard, low profile .750 gas block Armalite: carbine length gas tube 6 position buffer tube, spring and buffer 18 inch stainless fluted barrel (specs in pic below) Ke arms slt2 trigger. 10 round pmag. VG6 lamba muzzle Device