DJ619

Drilled barrel gas port to .093 functions flawless now. (Gas block 9clicks open 168gn)locks back on last round and not one FTF yet. Less than 1moa at 100yd. THANK YOU FOR ALL HELP EVERYONE.

Thanks. I got a .093 bit. Will drill out tomoro and test in next few days. A quality barrel is in near future tho. Not sure on brand yet? $300-$400 range. Been look at the FAXON FIREARMS 20" heavy fluted

Checked gas block it was aligned perfect.

Springco orange spring and 5.6oz buffer installed. Gas block fully open(15clicks out) 150grain eject but wouldnt pick up next round. Few stove pipes 178grain wont eject at all gb full open. 20in Barrel rifle length gas port is .077 should i enlarge?

Springco orange spring and 5.6oz buffer installed. Gas block fully open(15clicks out) 150grain eject but wouldnt pick up next round. Few stove pipes 178grain wont eject at all gb full open.

No 2.5" 5.6oz buffer

Springco orange spring and a h3 buffer on order.

Spring length 9.5" 25coils Outer length 7" 3/16 Buffer weight 3.810 oz Inner length 6" 15/16 (is flush with lower reciver at top of threaded part)

Called armalite today. Was told place a backorder online and it should be sent out within 4weeks... I can have tungsten buffer weights in few days. Would changing my weights in buffer require different spring? How long is a 308 carbine buffer tube supposed be?

Ya im feeling porked. Thanks for the advice. Once i get a new buffer setup i will report back.

This the only kit i can find with same deminsions as whats on it. Luth ar 308 buffer kit.

Im stuck with it. They had it for the first 2 months i owned it and thats when decided i got better luck fix it myself.

Having fail to feed and fail to lock open after last round. Local shop built gun. First testing it wouldnt cycle but few times till jam. Took back to shop. Got it back and cycled 110gn Fine but not 168gn or 150gn would jam. Bolt catch would realease at lightest bump of gun. Took back shop. Said it be few weeks before could try come up with solution and i juss left with it. So it had an ar15 bolt catch. I figured that out and put correct one in. Dpms? Lr308. Local shop branded lower. (Think was 80% they finished) 20in barrel. (Unknown brand shop doesnt remember) Rifle length gas system .077 gas port Buffer tube 7in internally. Buffer 3.8oz. Spring 9.5in 25coil Adjustable gas block. Slr7 maxed out 15 clicks. Tried all settings Forward assist is on backside of deflector and doesnt match where serrations are on bolt carrier. Can see silver plunger at bottom left of bolt Also every casing is being shrunk in 2 spots towards neck can see rings in pic. Close to 100 all look this way doesnt matter gn. Or brand From my measurements my gas tube is almost 1/2in in gas key on bolt and could go 1in? JAM once every few rounds. Casing 1 ring 1/4in from were bullet would be and another ring 1/4in from were gets bigger