LongDucDong

Thanks, I will buy a pmag and try to alter one of my factory clips. I sure don't won't to mess with this load. After one round to find where I was on the paper at 100 yds., I put four rounds in two joining holes less than a dime. I had 35 more test rounds I didn't even want to shoot after that. But I did, couldn't help myself. No other combo was as good. I did get a 1/2" out of one other load. Let you know later how the new mags work and how the mag alteration goes.

Thanks, I will get it swapped for the SSA-E. I'm new to the Geissele triggers and bought the SSA by descripton.

DPMS LR308, stainless bull barrel. Factory mags, 20 round. I have shot factory ammo without any problem. Hornady SP with soft tip go beat up feeding, Rem. core lock was fine. New Geisselle SSA trigger that I;m not overly impressed with. I'll keep working on it and see what I can figure out. Thanks again.

Searching for a trigger fix.

Hey Guys, New here. Lots of great info. Thus, i bought a Geissele ssa for my LR308. Installed and shot it today. Not impressed at all. Lot of creep in second stage. Not near as crisp as any of my Savage accuTrigger or my Timney on a Rem. 700. Any ideas to make it better or should i send it back to Midway for a different Geissele?

They fit the mag and are just inside. but when I try to chamber one, they bind in the bore neck, like the angle is too severe.

Are you guys single loading when your shooting groups? I am loading the Berger 168 target match.

Hey guys, I just joined and got some great load info this week. Found Varget 44.0 gr. shoots 1/4". My problem is I used the recommended COL of 2.795 and my bullets won't load out of the mag. I had to load them individually. Any suggestions to keep the group tight and still feed out of the mag?