Dillon parts - New to the market XL650 primer pocket swagger.

[tucson308]

Hi All!

Check out my ebay listings for top of the line tool steel 550, XL650 and RL1050 shell plates and powder funnels. You will NEVER rip the lips off of my shell plates, or wear them out. I have blanks pre machined with redesigned feed lips for 100% case loading , You just tell me the caliber you want and I ship inside of 5 days, but usually within two days, NEVER later! I have all 100% satisfied customer reviews on ebay and not one negative review of any of my products.

 

The latest item just released is a primer pocket swagger for the XL650. No more hand processing the pockets. Just one pass through the press for case prep, pour the cases back in the hopper and load. The units will sell for $72.95 including shipping and will be supplied with either a small or large rifle swager. both pins can be supplied for an additional $24.95

 

I have been developing the unit for 3 months and I'm now ready to release them to the market. Prickly Pear Ammo, here in Tucson is using this unit exclusively for processing .223 brass and is where all the development was done. These units preform as good , or better than any swagger out there, but it is done in the same pass as you re-size, de-cap and trim on the XL650.

 

All of my products carry a 100% lifetime gaurantee.

 

Respond to this add if you are interested in any of my products.

 

Thank you for looking!

G.S. Custom

Edited July 16, 2013 by tucson308

[Tripledeuce]

 I'm interested!

 Terry

[tucson308]

Hi Terry,

I'm assuming you are talking about the swager ? I finally finalized the pricing. The unit is $72.95 including shipping and will come with a small or large rifle swager pin - your choice. Both pins can be purchased for an additional $24.95.

I can send you an invoice through Paypal if you would like to purchase one.

Thank you for your interest!

Geoff