Ksgunguy

any links on mounts I could use?

Hi All, I have a Vortex PST 6-24x50 FFP on my current 308 AR and want to also attach a Red dot scope on the side. need some recommendations on how to attach it. thanks in advance

Hi all, so I finished my build and today was the first day I had a chance to shoot it. I only put 8 rounds down range before the rains came. Things I noticed was the first few shots the empty rounds did not eject. So I adjusted the adjustable gas block and the rounds went between the 2:00-4:00 o'clock direction. Some of the casing noted to be slightly bent ( not at the primer side of the case but the other side, the open side where the bullet is seated). I know I need to shot a lot more to get it broken in, but not sure what to expect. Afterwards I cleaned the barrel and dunked my BCG in mobile 1. I also had new magpul 20&10 round magazines so I just filled them up with ammo and hope to get those broken in as well. Suggestions ???. Or do I just keep on keepin on

Thanks will send target pictures once the weather gets nicer. Go Wichita State university !

Ok, done!!!!!!

No i'm not, I live in Wichita. but if you find you decide to go. let me know how it went

Sooooooooo what you are saying is a Clean gun is a safe gun?

Is this what happens when you do not check the head spacing?

I love my M2

I already have the vortex PST 6-24x50 awaiting on my ADM mount. will take final pictures before the cerakote custom job

here she is

What does everyone think about that ? Colt paired 60 million for them

I was wondering the same thing since his website says these are hand lapped ? What I really want to do is just shoot it . What's the worse that can happen?

So I received my barrel and was reading the instructions to properly break in the barrel: 1. clean barrel after every shot for the first 10-12 rounds or until copper fouling stops with a wet patch of solvent. 2. wet the bronze brush with solvent and stroke the barrel 5-10 times followed by another wet patch and than a dry patch 3. soak the barrel with a strong copper removing solvent until all the blue mess is removed from the barrel 4. start shooting 5 shot groups and clean after each one 5. after 25-30 rounds clean at normal interval of 10-25 rounds 6. you barrel is now broken-in my question is when I stroke the barrel with the bronze brush do I go back and forth or do I go foward and take the brush out and than repeat again. I was always taught to never go backwards. I's kind of like poop shoot. exit only thoughts?

I saw a how too guide here: http://point3airsoft.com/services/custom-paint-stencils/ but want someone other than me doing it