CA Compliant Bullet button

[Nereus]

? Can the CA compliant bullet button be replaced with a standard mag release or is the lower only milled for the bullet button? I KNOW all legal ramifications so leave that part alone. I ask because I will not be here forever.

[FaRKle!]

Bullet buttons can be removed with either a removal tool (<$10) or possibly flat head screwdriver depending on how far down the bullet button was screwed onto the mag catch.

[Robocop1051]

The "bullet button" and the standard magazine release are the same dimensions. Completely interchangeable. If you have a rifle with a CA compliant bullet button, you can swap to a standard magazine release in about 2-3 minutes with little/no tools.

 

If you travel in and out of the state, there are bullet buttons that can be disengaged with a tool, and become equivalent to a standard magazine release.

[Nereus]

Mahalo. I will evaluate a few options.

[Robocop1051]

Fwiw

I use Raddlock buttons.

[Nereus]

Raddlock looks workable. Easy to install? I already ordered the tool to remove the original equipment.

[Robocop1051]

Tool? Ugh... You can remove a magazine release by hand... and most bullet buttons can be removed/installed with a small screw driver.

[FaRKle!]

Raddlock looks workable. Easy to install? I already ordered the tool to remove the original equipment.

They're all easy to install.

I personally like the Vamfire MLD a bit more due to the larger diameter of the release button. You will want to use a dab of thread locker on it though.

[Nereus]

No worries. Tools make me happy

[Nereus]

After further review I went with the Raddlock. The only 4 turns out was more like 8 for me but it works perfect. Mahalo to Robo for the advice.