has any one built a AR10 dpms receiver and what blue print did you use

[mike]

I have noticed that the free blueprints out there the numbers for the AR10  ,safety, hammer and trigger very and I don't want to buy a drill jig because I own a mill with a DRO and don't want to scrap my DPMS blank or end up with a crummy trigger pull either so I was looking for some advive

[Matt.Cross]

I can confirm noone has built a AR10 DPMS here. DPMS has two patterns, LR-308 and their G2 platform. AR10 is Armalite, and a dissimilar pattern of receiver.

[dbwalker]

this might be a better place to post if your doing an 80% lower, I just finished one recently using a drill press, turned out great

, http://forum.308ar.com/forum/72-80-lowers/

[slugger43]

I think this will be helpful........

http://www.klstottlemyer.com/klstottlemyer.com/Prints_drawing_etc.html

[Toolndie7]

I have CORRECT drawings if you require them. Armalite is exactly the same as DPMS EXCEPT....the two trigger pins and safety hole, are all 3 are shifted forward towards barrel .059" as compared to dpms.

Edited October 12, 2015 by Toolndie7