Scorch95 Posted April 24, 2017 Report Share Posted April 24, 2017 When you slide the gas tube into the gas block should it be an easy fitment or do you need to kinda push it in so the pin holes line up? I'm looking at mine and I can really get it to line up perfectly. I'll upload a photo but it didn't catch the detail I had hoped for. I'm wondering if this is normal or if one of these components is slightly out of spec. Quote Link to comment Share on other sites More sharing options...
jtallen83 Posted April 24, 2017 Report Share Posted April 24, 2017 If you push does it line up better? Might be a tough go getting the pin drove through like the picture shows. Quote Link to comment Share on other sites More sharing options...
Scorch95 Posted April 24, 2017 Author Report Share Posted April 24, 2017 It kinda looks better when I really push on it. Quote Link to comment Share on other sites More sharing options...
98Z5V Posted April 25, 2017 Report Share Posted April 25, 2017 That's normal - if it just slipped in there, it wouldn't seal very well, and you'd need to shoot the hell out of it to develop a carbon seal. Pound a gas tube roll pin in that thing, and you'll be fine. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.