7.62X39 Build

[Armed Eye Doc]

3 minutes ago, sketch said:

is there a dimple on the bottom of the barrel to aling the gb set screw? if not you may want to do that? its kind of scarry to do the first time but start small and slow.. take your time !

I think there is one.  This was my first upper to put together so it may be elsewhere in the build as well.  The gas tube seems to go in the upper receiver with little resistance.

[Robocop1051]

Try a few different brands of mags too: ASC, C-PD, Stoner, D&H. Some x39 builds are just temperamental about the mags they want to run. 

[Armed Eye Doc]

10 minutes ago, Robocop1051 said:

Try a few different brands of mags too: ASC, C-PD, Stoner, D&H. Some x39 builds are just temperamental about the mags they want to run. 

I will get some of different brands.  

[MoriartiArmaments]

On 07.10.2017 at 9:10 PM, Armed Eye Doc said:

Here it is with the optic mounted and the sling (that still needs to be attached).  I'm taking it out tomorrow for testing.  I let a friend look it over and test fire it.  He said it did well the first few rounds then would not cycle the bolt at all. It did not have much lube on it, so that may contribute some.  But I think the gas block might have moved.  

Hey guys. Thank you for sharing this! :)

[Armed Eye Doc]

I attached the sling and tightened the gas block.  It ran several mags easily with no problems.  Great gun!! 

I used D&H mags and had no problem.