XH Buffer ?

[oli700]

Currently I have an Armalite carbine buffer system. The rifle shoots everything I put in it reliably. It runs a little too hard for my liking , creasing the brass off the rear of the ejection port bad enough that I cant get it out during the reloading process.......brass lands about 2oclock .

The gas clock is pinned and I like that so I am looking at the buffer ......The XH Buffer specifically.

 Quite a bit heavier than the H3 I have in it now , any experience or opinions with it ?..................hate to buy it then lose reliability, it needs to slow down though .

Thank you

[Robocop1051]

Have you tried just adding weight to your current buffer, and see if it makes any difference in performance for you?

[oli700]

I haven't, figured since the H3 has three tungsten , there wasn't much I could do.........suggestions ?

[survivalshop]

On 10/18/2018 at 5:52 PM, oli700 said:

Currently I have an Armalite carbine buffer system. The rifle shoots everything I put in it reliably. It runs a little too hard for my liking , creasing the brass off the rear of the ejection port bad enough that I cant get it out during the reloading process.......brass lands about 2oclock .

The gas clock is pinned and I like that so I am looking at the buffer ......The XH Buffer specifically.

 Quite a bit heavier than the H3 I have in it now , any experience or opinions with it ?..................hate to buy it then lose reliability, it needs to slow down though .

Thank you

Does the Dent hinder chambering ? ( after reloading )

[oli700]

1 hour ago, survivalshop said:

Does the Dent hinder chambering ? ( after reloading )

not so far