bent FFT .*&@#@

[308reloaded]

I opened safe to get upper and barrel out. FF tube rolled off shelf came down and hit safe frame , bent tube just before threads. I got it straight but now I will need to re-do black. 

Good side is I have the barrel installed . took 70 lbs of torq to get it to align the hole for gas tube.  everything is on order or in bound, except the BCG .  who will I order from is up in the  air.  JSE,

Does BCM sell BCG for the DPMS 308. if so I will order from them. need fullauto  BCG.  even if you are only shooting semi-auto  use the full auto BCG. it cycles better ,slower with less feed issues.  it is heavier  I have them in all my AR15. it is legal, 100%

[survivalshop]

Sorry to hear about the HG .

I think all 308 BCG are so heavy ,you won't have to worry about it .

Now a Full Auto BC ,not sure , they may be all full auto carriers.

I have worked on & built many select fire M16's, not sure if one is built for 308's .

There are select fire 308's out there.

After having a select fire FNHB & an M14 , I'm sure I don't want one . 

[imschur]

I have not heard of a BCM in 308 nor seen an auto dpms bcg in 308

[308reloaded]

i am not sure if they make then either , but if they do.. I want

[308reloaded]

my favorite fullauto come in 7.62 X 51  its called a mini gun and everyone should own or at least shoot one.  it does not go bang.  cycle rate 2000 to 10000 per min.

[survivalshop]

I can't afford to feed any of them any more .

[98Z5V]

my favorite fullauto come in 7.62 X 51  its called a mini gun and everyone should own or at least shoot one.  it does not go bang.  cycle rate 2000 to 10000 per min.

What kind of a minigun was that?  The Dillon M134 isn't anywhere near 10k rpm.  The older GE M134 was a little higher than the Dillon, but not like that. 

EDIT - what kind of FFT were you running that bent up like that?  I know, lots of questions...  <dontknow>

[308reloaded]

I have to dig up the spec's  I've never seen one fire at that hi rate but it what I was told they could do. 

I stand  corrected on the 7.62 X51  ge mini gun cycle rate

http://en.wikipedia.org/wiki/Minigun

[308reloaded]

[ EDIT - what kind of FFT were you running that bent up like that?  I know, lots of questions...  <dontknow>

it is the DPMS rifle length tube. it bent where the threads are I have it all straight again but will have to paint if I don't want to see mark where it bent. it has aluminum shiny spot now.

[SWshooter]

Don't worry, it will have alot of shiny spots in a couple years and a few thousand rounds. Look for a Birchwood Casey super black touch up pen. Make sure to shake it well before use.