Pistol Brace at a decent price

[shooterrex]

https://extreemtactical.com/trinity-force-tba10-breach-brace-pistol-stabilizer-stock/

This looks a lot like the KAC brace at a good price. I have 2 on the way.

 

[shooterrex]

The pistol braces showed up today. They tighten down snug with more than 1 little set screw like the KAK. 1 buffer tube was a little smaller diameter and I had to put a couple wraps of duct tape on the tube so the brace would clamp down properly.

[jtallen83]

1 hour ago, shooterrex said:

The pistol braces showed up today. They tighten down snug with more than 1 little set screw like the KAK. 1 buffer tube was a little smaller diameter and I had to put a couple wraps of duct tape on the tube so the brace would clamp down properly.

I recommend being very careful with any modifications to AR pistol braces. Once you go outside the manufacturers original design you are on your own with the ATF. 

[shooterrex]

This is a very old pistol tube that is a bit smaller. I am ordering another tube with a larger diameter. Yes no modifications to the brace.

[sketch]

slick looking mini sticks but whats the deal with the gap in the middle? is that an attachment point for length? like a clamp style gas block or scope mount? i do see a link ill check it. whats your thoughts so far? @shooterrex

[shooterrex]

18 hours ago, sketch said:

slick looking mini sticks but whats the deal with the gap in the middle? is that an attachment point for length? like a clamp style gas block or scope mount? i do see a link ill check it. whats your thoughts so far? @shooterrex

Gap in the middle is where it clamps to the buffer tube. You could adjust the lop a bit by where you clamped it down tight. There are 2 nuts and bolts to tighten to clamp the brace down.