MikedaddyH

I definitely want to learn how to load shotgun shells ... So I can load some cool stuff like a. Bunch of Videos I posted !

Deprimed 3 years worth of 223 cases and sorted the Lake City and the Federal brass. That was not fun ! Also sorted all of the 9mm brass from the last 4 shoots. 3 gallon tubs plus the tub from the last house that was deprimed.. There has to be more than 20 lbs of 9mm to work. I need more primers !

357sig #1 Federal Great brass #2 Sig -Great brass #3 A USA -Very Good brass #4 Speer -Good brass #5 Hornady -Good brass.

10mmAuto #1Starline - Great brass , strong as funk #2 Federal -Great brass #3 Hornady - Great brass #4 Sig -Great brass #5 A USA - Very Good brass #6 S&B -Good brass

40s&w #1 Federal - This is the best, strong ,pliable. #2 Winchester - Great brass #3 Sig -Great brass #4 Remington - Good brass

224V #1 Hornady - Great brass #2 Federal - Great brass but primer pockets wear after 5-6 loadings.

6.8spc #1 Hornady -Great brass #2 Starline -Great brass #3 Federal - Good but primer pockets expand after 5-6 loadings. #4 Remington - Good but primer pockets expands and rim wears.

308 #1 Winchester - great brass. Needs trimming only. #2 Lake City - Great brass #3 Hornady - Really good brass. #4 Remington - Good brass but soft.

223 #1 Federal - all around best case, primer pocket is an extra step but not a PITA. #2 Lake City - great brass but primer pocket is a real PITA. #3 PPU - really good brass ,almost no cars prep needed, primer pockets have no crimps. #4 PWC - good brass but a little soft and cases grows in length and need trimming every time. #5 Remington - good but soft ,don't like the heads.

Picked up another 1000 CCI 41 primers for the LC 62gr loads of 223/556. Primed a little over 700 10mm cases with Fed GM150M and Fed 150 primers this week.

Welcome from AZ !!

Here you go Tom !

I was thinking... We could make several stands cheap and portable. Angle iron base with a 2x4 bottom stand welded together then the top bracket and target sitting on top of the 2x4.

I can hit a chain at 100 yards with out even trying !

Base

Top bracket side view

Top bracket

Can someone reverse engineer one of these ?

Picked up 2200 Federal primers and 1000 CCI pistol primers for the 9mm. Stocked up for the reloading projects in the next few months.

Welcome from AZ !

Finished the last 56 cases , took about a half hour. Picked up some Federal primers, going to use those instead of CCI 41's.

Maybe... Just Maybe .... Every individual political candidate will get the boot and will end up unemployed. And morally sane people will be elected. It's early , I need to stop fantasizing.

We need to get a blue port-a-potty !

I got that one covered about 4 ways. The brass looks really good, rifle process is a little more time consuming than the pistol process. Worked on it for an hour and 10 minutes this morning for 56 pieces of brass . Including setup of two dies. Measured every piece. Love the Hornady die set. The Lee Quick Trim Die setup needs the power drill to be most effective. Go that route !!!

Trimmed with Lee Quick Trim 224V die. Good inside champfer ,but outside is barely touched.