Moving forward

[Robocop1051]

Small updates on projects and production. All three rifle formats are complete and in the CNC's as you read this. A small batch is getting ready for shipment, and then production should be in full swing.

 

As for "moving forward" I have a sneak peek to something I have been toying with as well. This is still FAR from complete... but it's very close!

[98Z5V]

I dig it, big time - you're moving the rear sight forward on that slide, so the RMR cut can be at the very back...  smaaaaart man. 

Looks like a Gen 3 slide?

[Robocop1051]

1 hour ago, 98Z5V said:

I dig it, big time - you're moving the rear sight forward on that slide, so the RMR cut can be at the very back...  smaaaaart man. 

Looks like a Gen 3 slide?

Oh just wait brother... This lil bitch is an open canvas! I have some BIG plans for it.

It is Gen3, but only because Gen3 frames are easier to make. I balanced the only mechanical differences between the Gen3 and Gen4, and the dual spring op rod was it. Everything else was tactile or cosmetic. The differences in single spring vs dual spring is almost negligible, except I have a LOT more options for the single spring. Also guys that want to shoot 1/2x hand loads for competition, can swap without having to buy a new unit.

[sketch]

damn bro this is looking very interesting! great ideas!!

[Rsquared]

Have I reminded you lately on how much that I HATE you? Fuker!

[blue109]

Just needs a paddle mag release ?

[Robocop1051]

22 hours ago, blue109 said:

Just needs a paddle mag release ?

Get out of here!! I haven’t abused my “warning” powers in a while. This totally warrants such abuse!!

[blue109]

Two kinds of people...those who know paddle mag release is better, and those who haven't used the paddle mag release enough to know its better. 

[98Z5V]

"And I shall lay the smacketh UPON THEE!!!"