shooterrex

Welcome from KY

And that thread was 5 years old.

Ok it is taking the place of the charging handle in the rear of the receiver. It needs to be removed to pull the bolt carrier out of the upper. Yes a little bit of gas comes out the back that's why there is a "Gas Buster" charging handle. I would find a plug the proper diameter and threads that takes a torx bit so I could screw it in flush. Locktite it in but removable with a torx bit. Or grind off what you need to get it to close. But a plug flush with the rear would be cleaner looking.

Please post pics of what you are talking about. This doesn't make a whole lot of sense.

Welcome from KY.

Welcome from KY.

South and east of LaGrange. About 20-30 minutes. About 15 miles NW of Frankfort.

Dion, Mine showed up today. Thanks!

Lube it up good and shoot it. My 2 pistols I built were like that for about 50 rounds. All good now.

Just bought 60 rnds of those to see if 1 or more of my guns like that load.

If it is a good price why not? DPMS made decent guns in MN.

That's only loaded to 850fps it should be safe for any single action. Out there. This not so much. Corbin DPX 225 gr @ 1200 fps. Can't get photo to load keep's timing out.

Welcome from KY

Welcome from KY

Welcome from KY.

Big portable guns. What not to like?

Think I got him mixed up with another new guy. Not sure.

Welcome from KY

Didn't OP say he wanted to use a suppressor? So he needs to use whatever muzzle device he needs for the suppressor he is going to use .

Only if they had ate it.

Glad you were able to pick it up with all the stuff going on. I have a Blackhawk with both cylinders. Sometimes I shoot acp but not often. We used to drill out the primer pocket a bit, prime then press the case down into a block of paraffin. Marked the case heads so they stayed out if the reloading brass. Put a towel in a cardboard box and shoot. Remelt paraffin and use again next time.