edgecrusher
-
Posts
6,207 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Gallery
Store
Everything posted by edgecrusher
-
I would love to see "full kit" ….. just saying.
-
And there it is! And that's why I need more of that sweet goodness! I as shooting the slug at 50 yds, it was very accurate, but at that point the 00 wasn't even on the steel silhouette
-
That's what I'm saying, although I do believe that he wasn't quite up to the proper amount of lube.
-
Yes, what Rene said Tom, it clearly shows how much thinner a commercial tube is at the threads.
-
aaahhhhhhhh! I hate you Mass!
-
I still think it's the gas block
-
To make it easier, could you gives a parts run down, it may expedite this process so we can better help.
-
NO, NOT NORMAL! With out knowing or hearing anything else, I would absolutely address this! Sounds as though your gas block isn't properly lined up. Start there, then go back to the range.
-
But hey, that's just fine,I've got some damn Canadian Thermolds! That will look wonderful in my Colt when I take a picture of it and post it on ar15.com!!!
-
Me too. The round is a 2 3/4 slug with 00 following it
-
I have run a few boxes through my 930SPX, have six boxes in reserve, and yes, it is hellacious! Badmotherfucking round for sure
-
Welcome, congrads on your start, good luck on your build
-
You are correct, and then shortly there after the fourth.
-
Welcome to the site, we are glad to have you! Nice trophies, good luck in the future <thumbsup>
-
<lmao> Jon is almost always posting around that time, I know because when I'm at work and you and Tom go to bed I look forward to his early morning posts!
-
Step in line there pooper scooper!
-
A-W-E-S-O-M-E !
-
Good post Jon, lots of facts unrelated to the common misconceptions of the plant
-
<thumbsup> <lmao> <laughs> nicely done men!
-
Saw the Moore crash live, very scary. There was also a real nasty snowboarding accident in practice, these guys push so hard, and their wipeouts are epic.
-
The dig on Powerman was not warranted in the least, and this donkey used him to get a god deal and then tried to throw him under the bus for being a fucking price gouger, good fucking riddance, I was nice in my initial post, but it brewed… and this is where I stand as a member of the forum, sans moderator status
-
I didn't and it came out fine, just used some steel wool. <dontknow>
-
Awesome that he's willing to learn! Bummer he got affected by a severe lack of QC at CMMG. Good luck, hope you help him out.
-
very nice! <thumbsup>
-
<lmao> <laughs> <thumbsup>
