shooterrex

Just get better before deer season. Otherwise LWM will have to come out and do all your totin for you.

They banned the stars and bars flags. They are not as woke as other sports but they are heading that way slowly.

Safety is pointed the wrong way.

People Eating Tasty Animals.

Glad it's running ok for you.

Welcome from KY.

Hmmm I just use the hay forks on the front of the tractor.

Thanks that works.

Anything that say milspec 308 is wrong. There is no milspec for the 308ar's like the 5.56 ones.

This will work. Slash does good work. https://heavybuffers.com/ar10carbine.html

Rise or LaRue over rock river any day.

The other thing I see wrong is your gas tube is a little short. Probably an AR-15 gas tube. Pick up an Armalite rifle length gas tube it is a bit longer. That will also slow the bolt just a bit.

Not near enough recoil system. KAK buffer and springco orange spring or complete Armalite carbine recoil system. Buffer should weigh in the 5.5oz range. Either one of the above should get things running. Your bolt is running to fast and the magazine hasn't raised the next round enough to feed correctly. That's why it's smashing the rounds into the feed ramps.

Why is it going back to the first post when I open a topic. This one is on page 3 and it went to the first post when I came back to it.

Rookie also and just earned 1 year when I've been here over 2. I can post pics on my phone. Android n Firefox.

Just change out the BCG and drive on. Toolcraft makes good ones.

Happy labor day. Shot a bit. Knocked down a tree and cleaned up some brush w/the bulldozer.

Looks like fun.

Now to the next part. The recoil spring in your PA10 probably doesn't have enough horsepower to strip rounds out of the drum mag when it is close to full. That spring in the magazine is stout to move all those rounds up. Try just loading 6 or 10 rounds in the drum and see if it will work. Your rifle also isn't broke in yet. These large frame AR's need a couple hundred rounds through them for everything to start working right. I replaced my PA10's recoil spring w/an Armalite AR10 spring.

Putting the magazine in the gun and racking the BCG is loading the gun NOT the magazine. It is actually unloading the magazine.

Try a tubing cutter for copper tubing for scoring the glass tubes.

The lever just is used to load the rounds. It has nothing to do with the rounds feeding out of the magazine except it should be down.

Not all ammo is the same. Different bullets, different powders w/different burn rates. You might need to open the gas block up a bit more to get the 180's to cycle. Also the new gas block probably isn't sealed w/carbon just yet. I open it up so it runs anything I put in it. It may recoil a bit more than it could but it eats everything I put in it.

Fold the lever down.

Bounce dryer sheets. Wipe funnel with the dryer sheet. No more static cling