shooterrex

Looks like fun.

Not a pic but watch the video. The good part comes after the replay of the Gretta girl. https://redstate.com/sister-toldjah/2021/05/27/australian-tv-show-host-wrecks-greta-thunberg-other-climate-activists-in-classic-must-watch-segment-n387564?utm_source=rsmorningbriefing&utm_medium=email&utm_campaign=nl&bcid=6cc3fd0c5bd764bbfe9ca3a9f9343984

I suspect your dimples are not straight under the gas port. You can fix that. Take the gas block off and look at the carbon ring around the gas port. Is it centered?

Ok you dimpled the barrel for the gas block. Did the gun run w/a fixed gas block? Bet if you take the gas block off the carbon pattern is to one side instead of centered. As long as the gas block doesn't touch the rails it shouldn't change your point of impact.

If it's not @12 o'clock it shouldn't have left the factory. It shouldn't be to late to send back to the factory if it's not right. Faxon is good about fixing screwups. If it works and you are happy with it then leave well enough alone. Did the barrel extension come loose a little bit? Those are installed before the gas port is drilled SO the gas port is at 12 o'clock

If my gas port was not at 12 o'clock when it was installed in the upper it would be going back to the factory.

Hi first off is this a rifle or carbine recoil system? The PA10's w/a carbine recoil system can be changed to a heavier buffer and spring. As far as easier charging, you need a lot more spring to control the greater bolt mass. How many rounds have you shot through it? The bolt will operate smoother after broken in. Please stop by the introduction section and tell us a bit about yourself.

Here is what I have. PM me your address and I'll drop them in the mail. I am leaving for Rolling thunder this week so it will probably be the end of next week before I get to the post office. These were on my PA10 from the factory.

I think I have all the stuff off my PA10 somewhere. I'll poke around in my box's the next day or two.

More like rare. Only 19 made. No pin hole for full auto sear.

I just picked up one of those. It looks well made. I haven't put in anything and shot it yet. Just ordered it as a spare. But then again there is a heavy barrel creedmoor barrel and an aero upper laying on the workbench.

And a 6mm ARC would let you compare between the Grendel and the 6ARC. Purely for scientific purposes of course.

By all means. You NEED a Grendel.

If it was built properly the castle nut should have been staked. That makes getting it loose a challenge till you break it loose.

Nice.

KAK makes good stuff.

Yep the ones JT linked. Just decide where you want one. Slide mount in the opening and install the bolt from the other side.

You need to buy and install the inserts.

Looks good.

I have that stock on my creedmoor. Good sturdy stock. Same height as A2 stock. Except mine is black not green.

This is what metric FAL mags look like. This is what you need for that platform.

I subscribe to the spare gun theory. I do have spare parts for some things but a spare gun is quicker than fixing one that doesn't work.

Is the bolt wet with lube? How many rounds has this rifle fired? This platform doesn't always run at first. Use a different brand magazine. Just a few things to look at.